![need to move altium 10 need to move altium 10](https://demo.documents.pub/img/378x509/reader019/reader/2020040314/5ad8a2f97f8b9a991b8d901d/r-2.jpg)
These routines use the 3D body, if there is one, or the copper and silk primitives to identify an object's clearance. In this mode, the same component clearance checking routines seen in previous versions of Altium Designer are used. Ignore Obstacles - default behavior, where the component can be moved regardless of creating a violation with neighboring component(s).Press the R key to cycle through component conflict resolution modes.Press and hold the Shift key to view dynamic alignment guides (green indicator lines) in relation to the pads of this, and nearby components.Press and hold the Ctrl key to view dynamic alignment guides (green indicator lines) in relation to the boundaries of this, and nearby components.When moving a component, the following smart actions can be performed, while the component is still floating on the cursor: Nudge by larger amounts (10 x snap grid value) by pressing the arrow keys while holding down the Shift key. Nudge the object by small amounts (according to the current snap grid value) by pressing the arrow keys.Press the X or Y keys to mirror the object along the X-axis or Y-axis respectively (on the same side of the board).Press the L key to flip the object to the other side of the board (where applicable).Rotation is in accordance with the value for the Rotation Step, defined on the PCB Editor – General page of the Preferences dialog. Press the Spacebar to rotate the object anti-clockwise or Shift+Spacebar for clockwise rotation.Press the Alt key to constrain the direction of movement to the horizontal or vertical axis, depending on the initial direction of movement.Press the Tab key to access the object's associated properties dialog, from where properties for the object can be changed on-the-fly.Move the object to the required position and click, or press Enter, to effect placement.Ĭontinue moving further objects, or right-click, or press Esc, to exit.Īdditional actions that can be performed during movement – while the object is still floating on the cursor – are: Position the cursor over the object in the design that you want to move and click, or press Enter. UseĪfter launching the command, the cursor will change to a cross-hair. This command is accessed from the PCB Editor, and PCB Library Editor, by choosing the Edit » Move » Move command, from the main menus. This command enables you to move any object in the current document.